Release liner & transcription film
TP・SG・SM
The PANA-PEEL Series and SG Series are polyester films which have been release layer processed. Since they can respond to various release properties and wettability and are extremely smooth, they are used as the base material for casting of acrylic resin and silicone-elastomer sheet.
Non-silicone type/low silicone type
Features
- Excellent heat resistance and solvent resistance and availability for stable release-transcription
- Type with various release properties changed between light release and ultra heavy release are available.
- Can cope with abundant base material thicknesses.
- Migration component is small and residual adhesiveness rate is high.
Type & features
| Product name | release | Characteristics |
| PET＊＊TP-01 | moderate | Release agent migration is small. Non-silicone type. |
| PET＊＊TP-02 | light | Lighter release than TP-01. Non-silicone type. |
| PET＊＊TP-03 | light | High heat resistance and high residual adhesiveness rate. Non-silicone type. |
| PET＊＊TP-05 | moderate | Better wettability than TP-01. Non-silicone type. |
| PET＊＊SG-1 | ultra heavy | Ink and resin are difficult to repelpeel. Little migration. Non-silicone type. |
| PET＊＊SM-1 | ultra heavy | Ink and resin are difficult to repelpeel . Little migration. Used for matte finish. Non-silicone type. |
| PET＊＊SG-2 | light | Type with releasebility for silicone elastomer specially increased. |
Composition
Applications
- Various kinds of resin film molding and transcription base material.
- Various kinds of ink transfer base material
- Die cutting process backing material, etc.
- Suitable as base material for heat dissipation sheet and other silicone elastomer sheet molding
Characteristics
| Product name | Release force[N/cm]* | Residual adhesiveness rate | Contact Angle | Surface wettability μN/cm(dyn/cm) |
|
| Normal state (RT × 24h) |
Heated (130°C × 30min) |
[％] | [deg] | ||
| TP-01 | 1.0 | 2.8 | 90 or more | 99 | 300under (under 30) |
| TP-02 | 0.2 | 2.8 | 85 or more | 108 | 300under (under 30) |
| TP-03 | 0.2 | 1.5 | 95 or more | 108 | 300under (under 30) |
| TP-05 | 1.1 | 2.8 | 90 or more | 95 | 300under (under 30) |
| SG-1 | 3.6 | 6.1 | 90 or more | 75 | 370（37） |
| SM-1 | 3.2 | 5.0 | 95 or more | 83 | 400（40） |
| SG-2 | 1.3 | 3.5 | 85 or more | 105 | 320（32） |
*Release force measurement method
Standard tape : 31B tape manufactured by Nitto Denko Corporation
Measurement conditions : Peeling speed 300mm/min, peeling angle 180°
※The above are measurement values and are not guaranteed.
※Example of PANA-PEEL® use. Silicone elastomer coating base carrier
Use process
